Select Heater - Sharp KH-6V08BS00-EU Bedienungsanleitung

Turn On and Turn Off the
Appliance
If the appliance is in Stand-By-Mode, it
is put in Operating-Mode by pressing the
On/Off button for at least 1 second. The
sounding of a buzzer signal indicates a
successful operation.
On all heaters a ´0` appears and the
heater Decimal Point flashes (1 sec on,
1 sec off).
If there is no operation within 10 sec,
the display of all the heaters will turn off.
If the displays are turned off, the heater
will be set into Stand-By-Mode.
If is pressed for more than 2 seconds
(in Operating-Mode), the appliance
switches off and is set into Stand-By-
Mode again. The appliance can be turned
off by pressing
other buttons are pressed simultaneously.
If residual heat from a heater remains,
this will be indicated in the corresponding
heat setting Heater Display.

Select Heater

If a single heater is chosen with the
corresponding Active/Inactive Heater
Button , the Decimal Point of the related
Heater Display will flash. For the selected
heater, you can set the heat level between
1-9 by touching the Heat Setting Slider
Buttons
at any time; even if
The slider button must be pressed within 3
seconds, otherwise the heater selection is
erased and heat setting dot will disappear
(Decimal Point). If there is no further
operation within 10 seconds, the heater
will fall back into the S-Mode.
The heat setting can always be changed
by pressing
level 1-9.
Each sliding operation or each display
change is quitted by a buzzer signal.
Turning on dual and triple zones (available
only in some models)
Turning on the dual zone
The activation of the dual zone is done
after selecting the desired heater by
actuation
buzzer signal. At the same time, the
corresponding Dual Zone Indicator goes
on statically. Pressing it for a second time,
the status of the dual zone toggles: it
changes from dual zone on to dual zone
off and back again.
The extension zone can be activated only
after a level between 1-9 is set on the
basic zone of the heater.
Turning on triple zones
A dual or triple zone can only be switched
on if the basic zone of a heater is set to
level 1–9 and the heater is selected, the
dot is on.
EN - 10
. This is confirmed by a
between