Using The Temperature Display; Using The Time Display; Using The Alarm Function - Silvercrest Z30170 Montage-, Bedienungsanleitung Und Sicherheitshinweise

urement unit lb (libra = Latin for pound) is
the equivalent of approx. 453.59 g and
equals 16 oz. The measurement unit floz
(fluid ounce) is the equivalent of approx.
28.4 ml. 100 ml is therefore the equivalent
of approx. 3.5 floz.
Weighingoutfoods:
note: When you are weighing heavy items,
place them slowly and carefully on to the
weighing bowl to avoid damaging the kitch-
1
en scale.
1. Place an ingredient into the weighing bowl
1 . The weight is immediately shown in the
display.
2. Press the ON/TarE button
reset the display. The display shows "0"
and the tare indicator
3. Now add the desired quantity of the sec-
ond ingredient. You can read the added
quantity directly in the display.
4. Repeat steps 2 and 3 until all the required
ingredients have been added.
j
Note that the maximum load on
the scale is 5 kg.
5kg
note: If the scale is overloaded, then the
display shows "
note:If no button is pressed within a peri-
od of two minutes, the kitchen scale's dis-
play automatically shows the time.
  U singthetemperature
Q
display
j
Press the MODE/+ button
device enters the temperature mode. This
comes after the weighing mode.
j
Temperature measurement is carried out at
an interval of approximately 10 seconds.
j
You can press the Digital timer/UnIT/
Alarm/- button
between °C and °F.
12
note:If no button is pressed within a peri-
od of two minutes, the kitchen scale's dis-
play automatically shows the time.
49402_Content_LB3.indd 9
to zero
2
will light up.
20
".
until the
5
to switch the indicator
4
 Usingthetimedisplay
Q
j
Press the MODE/+ button
vice enters the clock mode. This comes after
the temperature display.
j
The display shows the time (hours:minutes).
j
If you wish to change the time to another
value, proceed as described in the section
"Setting the time".
note:The device continues to show the
time unless the device is switched to anoth-
er function by you pressing the MODE/+
button .
5
  U singthealarmfunction
Q
j
Press the MODE/+ button
device enters the alarm mode. This comes
after the clock display.
j
The display shows the time of day.
j Press the SET/WEIGHT MODE button
to enter the settings mode. The minute value
flashes.
j
You can use the MODE/+ button
Digital timer/UNIT/Alarm/- button
to set the value.
j
Press the SET/WEIGHT MODE button
to store the set value and move on to setting
the hours. The hour value flashes.
j
You can use the MODE/+ button
Digital timer/UNIT/Alarm/-button
to set the value.
j
Press the SET/WEIGHT MODE button
to store the set value and leave the settings
mode.
  n ote:If no key is pressed within 10 seconds,
the set value will stop flashing and the
alarm time is set to the value shown in the
display.
j
Press the Digital timer/UNIT/alarm/- but-
ton to start the alarm function. The
4
Alarm symbol appears in the display.
18
j
You can switch off the alarm function by
pressing the Digital timer/UNIT/alarm/-
button again. The Alarm symbol
4
disappears from the display.
Operation
until the de-
5
until the
5
3
or the
5
4
3
or the
5
4
3
18
GB/IE/CY 9
10.05.10 17:54