Do not use abrasive or antibacterial cleaning agents. Excessive concentrations of cleaning agents
may eventually cause the plastic to crack. Throw away the cups and lids if cracking occurs.
2
Sterilise the cups and lids right before you use them again.
The cups and lids are suitable for all methods of sterilisation.
Environment
-
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 15).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips AVENT website
at www.philips.com/AVENT or contact the Philips Consumer Care Centre in your country
(you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care
Centre in your country, go to your local Philips dealer.
troubleshooting
Problem
The appliance does
not work
The blade unit or
motor unit is
blocked.
The motor unit
gives off an
unpleasant smell
during the first few
times of use.
The appliance
makes a lot of noise,
smells, feels hot to
the touch, emits
smoke, etc.
The lid of the
blender beaker
leaks.
Possible cause
The appliance is equipped
with a safety lock. If the
blender beaker or wet mill
beaker has not been
assembled properly onto the
motor unit, the appliance does
not work.
There is too much food in the
beaker.
This is normal.
There is too much food in the
beaker.
You let the appliance operate
too long without interruption.
You have not placed the lid
properly.
Solution
Press the on/off button to make sure that
the appliance is switched off. Then check
whether the beaker has been assembled
properly (see chapter 'Using the
appliance').
Switch off the appliance and process a
smaller quantity.
If the appliance continues to give off this
smell after you have used it a few times,
check whether the processing
quantity and processing time are correct.
Switch off the appliance and process a
smaller quantity.
Do not operate the blender for more
than 1 minute at a time. Do not operate
the wet mill for more than 30 seconds at
a time.
Make sure the lid of the blender beaker
has been properly placed.
EngliSh
11