Operation; Function Selecting; Preselecting Rotational Speed - Parkside PBH 1500 D4 Originalbetriebsanleitung

Using the chuck:
Insert the chuck key into one of the three
holes above the geared rim. By turning the
chuck key clockwise, you can now close
or tighten the drill holder. Turning the key
counter-clockwise will loosen the clamps.
NOTE
Fixing a drill unevenly or slightly off-center in
the wheel-rim chuck
vibrations and excessive wear and tear.
To avoid this when fixing the tool, apply
the chuck key to all the 3 positions on the
wheel-rim chuck
WARNING!
► Do not use the wheel-rim chuck
hammer drilling or chiselling!
PBH 1500 D4
can cause excessive
one after the other.
for

Operation

NOTE
Do not operate the function selector until
the machine comes to a complete stop.
Changing the function during tool rotation
can damage the machine.

Function selecting

Press and hold the function selector release
switch .
Turn the function selector
symbol.
Release the function selector release switch
to fix the function selector
The functions are marked as follows,
Drilling. For drilling wood, steel
and etc.
Hammer drilling. For drilling
concrete and granite
Chisel position adjustment. For 12
chisel positions adjustment
Chiseling. For light chiseling or
chipping work.

Preselecting rotational speed

You can use the rotational speed preselector
adjusting wheel to preselect the rotational
speed.
Work out the right setting with this practical
test:
GB
IE
NI
to the required
.
105