Voltage Supply; Opening And Closing - Bosch DCU 220 Betriebsanleitung

en 24 | DCU 220 | Operation
5. Operation
5.1

Voltage supply

The DCU 220 can be operated with the following volt-
age supply:
R
Storage battery
R
Power supply unit
!
Only use the power supply unit included in the scope of
delivery.
5.2 Storage battery operation
i
For additional information on storage battery opera-
tion, see the "User manual DCU 220" on the desktop.
5.3

Opening and closing

Follow the steps below to open the DCU 220:
1. Pull the latch () upward to release the clip ().
2. Pull the clip downward.
3. Open the screen ().
Fig. 9: Opening DCU 220
Follow the steps below to close the DCU 220:
1. Close the screen.
2. Push the latch upward.
3. Engage the clip in the cover.
4. Push the latch downward until it locks in place.
|
1 689 989 221 2014-11-26
5.4 Switching on
!
To avoid the formation of condensed water, allow the
DCU 220 to adjust to ambient temperature before
switching on the DCU 220!
1. Turn on the DCU 220 by pressing the
than 2 seconds.
i
The start screen is always displayed after switch-on.
The applications displayed can be selected on the
start screen.
2. Select the mode in which you want to work.
3. Start the application that you want to use.
CAUTION – Risk of injury from triggering
the airbag with attached DCU 220!
If the DCU 220 is attached to (suspended
from) the steering wheel, injuries could result
from unintentionally triggering the airbag.
¶
Never attach the DCU 220 to the steering
wheel.
5.5 Turning off and standby mode
Weitergabe sowie Vervielfältigung der Zeich- Rz 10
nungen sind nicht gestattet und müssen
streng vertraulich behandelt werden. Alle ( )
Rechte sind bei ads-tec GmbH nach DIN 34. Druckdatum/ print date: 17.12.2010
strictly confidential according to DIN 34. File:Airbag Lenkrad + TT13 Doku 130
i
Turning off and power management are described in
the user manual.
5.6 Touch screen with stylus
i
Operation is described in the user manual.
key longer
Robert Bosch GmbH