Connecting - AXTON C208 Bedienungsanleitung

CONNECTING

E
C208 / C408 / C508
IMPORTANT: DISCONNECT THE +12V MAIN POWER CABLE
FROM YOUR CAR BATTERY BEFORE ANY CONNECTING WORK
IS CARRIED OUT!
Recommended Power Cable Cross-Sections and Main Fuse
Values (for +12V and Ground cable based on 5m +12 V cable)
Model Cross-Section
C208 8-20 mm
C408 20 mm
C508 20 mm
It is recommended to connect your amplifier as follows:
Make sure your head-unit is turned off and the volume control is
1
in its minimum position.
RCA outputs of your head-unit to respective RCA inputs of your
2
amplifier (see „Connecting Diagrams" on pages 29 - 32 of this ma-
nual).
Sub pre-outs from head-unit should be fullrange signals because lo-
wpass pre-out signals always affect the filtering electronics of ampli-
fier! In case of doubt just 'double' a fullrange front or rear pre-out by
using Y-adaptors.
Main Fuse
2 30-40 A
2
60 A
2
60 A
3
Remote lead connection from head-unit to amplifier.
Speaker cables to respective speakers or passive crossovers. Make
4
sure to keep correct polarity! " " to " " and " " to " ".
For Mono 1-channel mode use the two terminals " " and " " mar-
ked BRIDGE!
Min. impedance for bridged mode is 4 Ohms!
Ground connection to chassis ground or -12 V negative battery
5
pole. If possible keep ground cable as short as possible and make
sure chassis contact is well sand-papered, i.e. clean from any paint,
rust or dirt for maximum contact.
+12 V power connecteonto positive battery pole. Do not forget to
6
install a main fuse within 30 cm of car battery (fire hazard)!!!
Do not connect +12 V cable to battery before re-checking every
other connection on the amplifier!
Turn-on your head-unit keeping your volume at the minimum. The
green status LED on front of the amplifier heat sink should light up
now. If not, turn-off your head-unit and re-check all wiring to and
from the amplifier for missing or faulty connections.
29