Installation - Velleman SPBS7 Bedienungsanleitung

3. Installation

• The Sensors
Make sure no part of the vehicle (bumper, towing hook) fall into the detecting range of the sensors.
Mark the installation spots on the bumper (see fig. for the installation interval). Drill holes using a powerful electric drill (not
incl.) and the included hole saw (Ø 22mm). Insert a sensor into each hole and connect to the control box.
Do the same for the camera. Instead, use the included hole saw of Ø 25mm. Insert the camera into the hole, the sticker in
the upper position. Be careful not to damage the connection wires.
• The Control Box, Buzzer And Display
Locate the control box and the buzzer in the boot, away from rain, heat and shocks. Use the included double-sided tape.
Make sure to lay the wiring in such way to avoid damage or accidental disconnection. Place the display on the dashboard.
Make sure the installation spot will not hamper while driving.
SPBS7 4 VELLEMAN