Wiring Diagram; Putting Into Operation; Basic Setting - Emos P5601N Bedienungsanleitung

Mounting the thermoregulator with mounting plate
Place the mounting plate onto the desired spot on the wall and mark two openings for mounting.
Drill two holes 6 mm in diameter in these spots.
Insert wall plugs and attach the mounting plate with two screws (figure A).
Check that the plate is firmly fixed.
Carefully mount the thermoregulator onto the mounting plate (figure B).
Fasten the thermoregulator by placing the left opening in the shape of a keyhole onto the screw first,
then moving the regulator right and pressing it in place.
To remove the thermoregulator from the plate, use a screw driver and carefully push into the right
opening and remove the thermoregulator from the plate.
Note: You don't need wall plugs for wooden walls. Drill two 2.7 mm holes instead of the 6 mm ones.

Wiring Diagram

Putting into operation

Remove front cover and insert 2× 1,5 V AA batteries.
Only use alkaline batteries, not rechargeable ones.
Insertion of batteries starts the thermostat and activates the display.
If the thermostat is not working properly, please check polarity of batteries, charging state of the
batteries, or press the Reset button.

Basic setting

Note: Remember that the first pressing of a button activates display backlight, the next pressing
sets values/functions.
Setting day/time
Set the current day by pressing the D button repeatedly (1–7 = Monday to Sunday).
Set the current hour by pressing H repeatedly, set the current minute by pressing M repeatedly .
Note: When you press and hold a button for 2 seconds, the setting process is accelerated.
Displaying/setting comfort temperature and economy temperature
Press and hold Temp to go to the temperature display/change mode.
Connection terminals are at the back of thermostat.
Terminals are marked with COM and NO. It is a
typical single-pole (SPST) contact.
4