► Do not operate the unit without the AIR FILTER.
en
► For safety purpose, the heater will break for 2 minutes
after running for 8 hours continuously, then restart,
IT
whatever the set time has been reached or not.
► During the break, the fan keeps working for heat-
DE
dissipating. To turn off the unit, press the "POWER" button
(the set time will be cleared). When the water tank is full,
ES
the set time will be cleared, too. If the time was not set,
the machine will shut off automatically after 24 hours.
► While using DRYER mode for clothes, please keep
FR
the unit AT LEAST 40CM away from the objects (ex. the
clothes) and ensure no water will drip into the air vent
NL
of unit. Please refer to the illustration as below for the
minimal distance from each direction. (FIG. 8).
PT
► This unit is equipped with tilt switch for overheat
protection. While the unit is tipped, the unit will stop
automatically, the POWER indicator will turn into RED and
DA
the unit will beep 3 sounds for warning. After repositioning
the unit upright, press POWER button to re-start.
FI
► Self-Diagnosis: If the room sensor, humidity sensor or
tip-over device is out of function, the unit will beep 3 times
NO
for warning, the POWER indicator would turn into RED
and the unit will turn OFF.
SV
►►
7. DRAINAGE
►
While the water tank is full, the unit will stop working for
PL
self-protection and:
RU
► The water full indicator
► The unit will buzz 10 beeps to remind you. * To stop
CS
the buzz, you may press ON/OFF button to turn off the
unit.
HU
► To empty the tank, please follow the steps:
1. Hold the unit with one hand to make it stand firmly.
SL
2. Pull out the tank squarely from the unit.
3. Grasp the water tank handle, remove the cover of the
TR
tank, empty the water from the drain.
4. After the tank was empty, return the water tank to its
HR
position, make sure it is properly positioned, so the ‚water
full' sign can go out and your dehumidifier is operating
LT
again.
PLEASE NOTE, IF THE WATER TANK HAS
LV
NOT BEEN POSITIONED WELL, THE WATER
FULL INDICATOR WILL TURN INTO RED AND
ET
THE UNIT WILL KEEP BUZZING.
CONTINUOUS DRAINAGE
RO
1. When the dehumidifier is operated in very high
humidity, the water tank will require more frequent
SK
drainage. In this condition, it may be more convenient
to set the unit up for continuous drainage with the
BG
following procedures: (FIG. 10):
2. Cut off the cover of the continuous drain at the unit
back. Unplug the water plug.
UK
3. Connect the drain hole with a water tube of inner
diameter 12mm. * Please note, the water tube is not
BS
supplied with the unit.
4. Pull out the water tank, plug the dropping gate inside
EL
the unit with the water plug taken from the continuous
drain.
ZH
5. Return the water tank to its position.
will light on.
►►
8. MAINTENANCE
►
Always unplug the unit from the mains and wait for at
least one hour before carrying out any maintenance or
cleaning of the unit.
CLEANING THE BODY
Use soft cloth to wipe the unit clean.
Don't ever use volatile chemicals, gasoline, detergents,
chemically treated clothes, or other cleansing solutions.
These all could possibly hurt the cabinet.
CLEANING THE FILTER
Draw out the air filter from the rear of the unit. (FIG. 11)
► For dust filter (washable filter): (FIG. 12):
1. Use a vacuum cleaner or tap the filter lightly for easy
cleaning. If the filter is particularly dirty, use warm
water with a small amount of medium strength.
2. Make sure the filter is completely dry before replacing.
3. Do not expose the filter to sunlight.
FOR ACTIVE CARBON FILTER:
This filter is not washable. Its life span is variable and
depends on the ambient conditions where the appliance
is used. The filter should be checked periodically (about
every 6 months) and replaced if necessary.
STORAGE
If not use the unit for an extended period of time. Please:
Turing the unit off, unplug and tidy AC cord.
Completely empty the water tank and wipe it clean.
Cover the unit and store where it will not receive direct
sunlight.