Configuring Via The Service Interface; Menu "Production Settings - Mennekes Amton Premium Installationsanleitung

6.4 Configuring via the service interface

Requirements for Internet browsers:
„ JavaScript activated
„ Microsoft Internet Explorer 11 or higher
„ Mozilla Firefox v30 or higher
„ Google Chrome v35 or higher
„ Opera v20 or higher
f Enter the IP address of the device and port (25000) in
the address bar of your Internet browser.
Î "6.3 Network connection"
f Enter PIN3 (installation PIN).
9 The main menu of the service interface opens.
When entering the PIN1 (APP PIN), no changes in
the "Installation Settings" menu are possible.
f Synchronize time.
Î "6.6 Time synchronisation"
A fault message appears on the LED information
field if the time is not synchronized.
The following submenus are displayed:
„ "Production Settings": display of the manufacturer set-
tings and hardware / software versions.
„ "Installation Settings": making settings for commission-
ing.
„ "User Settings": making customer-specific settings.
„ "Whitelist": defining RFID cards (users).
„ "System": backup of the settings made, restarting the
device, updating the software.
f Configure the device taking into account the circum-
stances and customer requirements.
f Save the set configuration by clicking the "Submit" but-
ton.

6.4.1 Menu "Production Settings"

The menu "Production Settings" displays factory settings
and the hardware / software versions. You cannot make
any changes here.
Wallbox Data
VALUE Description
HMI HW Version Hardware version HMI
HMI SW Version Software version HMI
HMI Type HMI type
HMI IO Status Status of inputs and outputs
HMI Temperature HMI temperature
Internal [°C]
HMI Temperature Device temperature
External [°C]
HMI Error Code HMI error code
RFID Version Version of the RFID card reader
WLAN Version Version of the WLAN module
HCC3 HW Version Hardware version of the HCC 3
HCC3 SW Version Software version of the HCC 3
HCC3 IO State Status of the inputs and outputs of
the HCC 3
HCC3 CP/PP State Status of CP/PP signal contacts
HCC3 Error Code Error code of the HCC 3
AMTRON Operating mode of the device
Operation Mode

AMTRON name Name of the device
AMTRON NDN Network devices name
AMTRON State Operating status of the device
AMTRON RS485 Network address of the device with
Address active RS-485 bus connection (SCU
mode)
AMTRON Plug-in system of the device
Connector Type
AMTRON No. of Number of mains phases
Phases
Operating manual AMTRON
Xtra (E/R), Premium (E/R/W) "5.1
Functional description of the
operating modes"
EN
21