Specifications - Makita 3706 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shoe
1-2. Thumb screw
2-1. Bit
2-2. Collet nut
2-3. Shaft lock
2-4. Adapter
2-5. Wrench
2-6. Loosen
2-7. Tighten
3-1. Adapter
3-2. Collet nut
3-3. Collet cone
8-1. Shoe
8-2. Loosen

SPECIFICATIONS

Collet chuck capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting gypsum, wood, plastic
and soft wall tiles.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
8-3. Tighten
8-4. Thumb screw
9-1. Shoe
9-2. Circular guide
9-3. Projections
10-1. Shoe
10-2. Circular guide
10-3. Thumb screw
11-1. Knob
11-2. Tighten
11-3. Loosen
12-1. Knob
13-1. Thumb screw
13-2. Vacuum cover
Model
-1
)
Overall length
Net weight
Safety class
) : 82 dB(A)
pA
) : 93 dB(A)
WA
ENE012-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
ENF002-2
Work mode : rotation without load
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
14-1. Circular guide
14-2. Projections
14-3. Vacuum cover
15-1. Circular guide
15-2. Thumb screw
15-3. Vacuum cover
15-4. Loosen
15-5. Tighten
16-1. Vacuum cover
16-2. Hose 28
16-3. Hose for vacuum cleaner
17-1. Vacuum cover
17-2. Hose 28
17-3. Dust collector
3706
3.18 mm, 6.35 mm
32,000
250 mm
1.1 kg
/II
2
) : 2.5 m/s or less
h
2
ENG900-1
ENG901-1