Maintenance And Storage - Lanaform Vapolux Gebrauchsanleitung

MAINTENANCE AND STORAgE:

EN
If the water is hard, that is to say it contains too much calcium or magnesium, it may deposit a "white powder" inside the
unit and cause a heavy scale on the surface of the reservoir, on the transducer (metallic button producing the ultrasound)
and on the internal walls of the water reservoir. The presence of any scale on the surface of the transducer will greatly
reduce mist production.
We strongly advise you to:
1) Clean the reservoir every 3 days, and to clean the transducer every week;
2) Change the water in the reservoir every two days so that it remains fresh.
3) Clean the unit completely to avoid any risk of bacteria and check that it has completely dried when it is not being used.
4) Clean regularly the filter.
To clean the transducer:
1) Place 2 to 5 drops of vinegar on the surface and leave for 2 to 5 minutes.
2) Brush away any deposit from the surface using a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the transducer with clean water.
4) Do not use soap or any other alkaline substances to clean the transducer.
To clean the reservoir:
1) Clean the reservoir using a soft cloth, together with some vinegar if there is any scale or calcium deposits inside;
2) If the scale covers the safety switch, place a few drops of vinegar on it and clean it with a soft brush;
3) Rinse out the reservoir with fresh water.
Storage:
1) Clean and dry the ultrasonic humidifier carefully.
2) Allow it to dry completely before putting the unit away. Do not store the unit with water still remaining in the base
unit.
3) Store the unit in a cool, dry place, out of the reach of children.
FAULTS AND CORRECTIVE ACTIONS
Should a fault occur during normal use, please consult the table below:
Fault
Unit does not blow, no mist
6
Possible causes
No power.
Main power switch off.
The water level is too high.
Leak from water reservoir
Corrective action
The device is not plugged in correctly
or your power supply is defective
Switch on the main power switch.
Remove some water.
Close the lid correctly.