Hints And Tips; Care And Cleaning; Cleaning The Filter - AEG LAVATHERM 65771DIH Benutzerinformation

16 www.aeg.com

10. HINTS AND TIPS

10.1 Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Anti-crease (Anti-kreuk)
and Time Dry (Tijd) buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry

11. CARE AND CLEANING

11.1 Cleaning the filter

At the end of each cycle the indicator
Filter is on and you must clean the filter.
The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
- the standard dry laundry
5. Push the Start/Pause (/Pauze)
button again and again until you set
necessary degree.
6. To memorise the setting, push at the
same time the Anti-crease (Anti-
kreuk) and Time Dry (Tijd) buttons
for approximately 2 seconds.
10.3 Deactivating the Tank
(Reservoir) indicator
The water container indicator is by
default on. It starts to light at the end of
the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Anti-crease (Anti-kreuk)
and Delay Start (Startuitstel)
buttons.
One of 2 configurations is possible:
• the Tank (Reservoir) indicator: is
on and the symbol
into the view - the water container
indicator is permanently on
• the Tank (Reservoir) indicator: is
off and the symbol
into the view - the water container
indicator is permanently off
goes
goes