To Suck In And Hold A Blind Rivet; To Empty The Spent Mandrel Container; Maintenance And Care; To Oil Jaws - Gesipa TAURUS 1 Betriebsanleitung

7.4

To suck in and hold a blind rivet

This function is used to hold the blind rivet in the nosepiece for riveting vertically downward.
• Using a pin (e.g. rivet mandrel), push the slide valve (No. 39) in the tool head as far as it
will go to the left or right.
• After the blind rivet setting tool has grabbed the rivet, push up the slide (No. 41) so that
it locks in. To switch off the suction, push down the slide (No. 41).
• The complete suction function of the blind rivet setting tool is deactivated by pushing
back the slide valve (No. 39).
7.5

To empty the spent mandrel container

• Thespentmandrelcontainer(No.36)mustbeemptiedingoodtime;overfillingwill
cause the blind rivet setting tool to malfunction.
• Unscrew the spent mandrel container (No. 36) by turning anticlockwise, collect spent
mandrels in suitable container.
• Screw on spent mandrel container (No. 36).
8.

Maintenance and care

The complete grip mechanism must be maintained regularly.
8.1

To oil jaws

• Disconnect the blind rivet setting tool from the compressed air supply.
• Unscrew steel head sleeve (No. 2).
• Dip the complete jaw mechanism up to the O-ring (No. 3) into an oil batch or wet jaws
(No. 5) with oil and allow to drip off.
• Reassemble in reverse order.
GB
21