Safety Instructions; Technical Features - Rapid LITHION BGX300 Bedieneranweisung

Safety instructions:

Warning! Read carefully before using
the glue gun – hot melt applicator.
Failure to follow the warnings and
instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
Work area safety:
Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
Do not operate tool in explosive atmospheres,
such as in the presence of flammable liquids,
gases or dust.
When applying at a height, take all the necessary
precautions to ensure that the glue does not run
onto the operator or onto any object.
When you have finished using the tool, wait until
it has cooled before to store it.
Electrical safety:
Do not use or store the tool in damp or
wet conditions. Do not expose it to
water or other fluid substances in any
way.
Never pull the cord to unplug the charger.
The appliance must be disconnected from the
supply means when removing the battery.
Do not use the tool if any part is damaged or
defective.
Personal safety:
Both the glue and the nozzle of the tool can reach
temperatures up to 200°C (400°F).
Avoid all skin contact. If burnt, plunge the burn
under cold water. Never attempt to remove
solidified glue from burnt skin without medical
assistance.
This appliance is not intended for use by persons
(Including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use of
the appliance by a person responsible for their
safety. Children should be supervised to ensure
that they do not play with the appliance.
GB
Batteries safety:
Never attempt to open for any reason.
Do not expose the battery to water and any other
liquids.
Do not expose the battery to heat.
The battery is to be disposed of safely.
Do not store in locations where the temperature
may exceed 40°C.
Charge only at ambient temperature between 10°C
and 40°C.
Charge only using the charger provided with the
tool.
Charger safety:
therefore no earth wire is required.
Always check that the mains voltage
corresponds to the voltage on the rating
plate.
use only.
Use your charger only to charge the battery in the
tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
Do not expose the charger to water.
Do not open the charger.
Replace the charger if the wire is damaged.

Technical features:

Specifications:
1 – Tool support
2 – Nozzle
3 – On/off switch
4 – Tool LED light
5 – Trigger
6 – Socket
7 – Battery unlocking button.
8 – Battery
9 – Plug
10 – Charger
11 – Charger LED
Tool:
Power rating:
Battery life:
Battery:
Voltage:
Capacity:
Time of charging:
Charger:
Input:
Output:
Intensity:
Glue:
12
The charger is double insulated;
The charger is intended for indoor
30 W
1 hour
7,4 V
2600 mAh
< 4 hours
100-240V 50-60Hz
8,4 V cc
1000 mA
Rapid Ø12 mm