Playback From An External Device Via Bluetooth; Playback From An External Device Via Aux - Exibel BTX1500 Bedienungsanleitung

Playback from an external device via Bluetooth

1. Switch the speaker on as directed above.
2. Press [ MODE ] on the speaker or on the remote control until the Bluetooth
indicator (1) flashes. The speaker is now detectable for other Bluetooth devices.
3. Activate Bluetooth on the device to be paired with the speaker.
4. The speaker will appear on your device as BTX1500, select it and pair it with your device.
5. Once connection has been established the Bluetooth LED will light steadily.
6. Start playback on your device. Set the desired volume levels both on the external
device and the speaker. The playback can be controlled from the speaker, remote
control or from the external device.
Note:
• If you are prompted to enter a PIN code on your device, you should enter 0000
(four zeroes). Certain devices may also require you to approve the connection.
• If you have connected a mobile phone to the speaker via Bluetooth and receive
a call (or make one) whilst you are listening to music, the music will be switched off
automatically. Once the call ends, music playback will automatically be resumed
(if your phone settings support this).

Playback from an external device via AUX

1. Switch the speaker on as directed above.
2. Plug a 3.5 mm audio cable into the AUX IN socket (12) on the speaker and
connect the other end to your device.
3. Press [ MODE ] on the speaker or on the remote control until the AUX indicator (7)
comes on.
4. Start playback on your device.
5. The volume can be adjusted using the controls on the external device, the speaker
or the remote control.
6. Other playback settings can be controlled from the external device.
Note: You cannot change track on the speaker or with the remote control when
an external device is connected via the AUX IN socket.
Connecting a device using NFC (Near Field Communication)
1. Switch the speaker on as directed above.
2. Press [ MODE ] on the speaker or on the remote control
until the Bluetooth indicator (1) flashes.
3. Activate Bluetooth and NFC on the device you intend to
connect to the speaker.
4. Place the part of your device where the NFC antenna is
situated (refer to the instruction manual of your device if
you are unsure) against the location of the NFC connection
on the speaker. Information about pairing with the speaker
will be shown on your external device. Follow these instructions to connect.
5. The Bluetooth LED will shine blue once the speaker has been successfully connected.
6
AUX IN