Out Of Range Warning - miniland baby digimonitor 2.4" Bedienungsanleitung

5.2.2.6. REMOTE FUNCTION
When parent unit is on standby mode, and you want to confirm that the
connection between both units is reliable:
1. Press the remote button (8) and the green link LED will flash on the parent
unit.
2. Once the parent unit is linked to baby monitor, the green LED will light up (11).
3. Press and hold the remote button (8) to wake-up or go to sleep mode.
Note: When the link LED (11) is continue flashing in red, you are out-of-range or
there is interference. Move your parent unit closer to baby unit to link up with it.
5.2.2.7. TALK TO THE BABY UNIT
Press and hold the PTT button (12) on the parent unit to send voice to the baby
unit. The talk back function will be activated while you are pressing the PTT
button (12).
5.2.2.8. ZOOM
The zoom can be displayed in 4 corners by pressing the menu button (4) on the
parent unit.
Press the menu button (4) to view the upper left side corner in the whole LCD,
press the menu button (4) for a second time and it will display on the upper right
side corner, press once more time and it will show the lower left side corner and
press for the fourth time to show the right side corner.
Pressing the menu button (4) once more (fifth time) it will go back to normal
monitoring display.
5.2.2.9. VOLUME
You can adjust the volume (between 8 levels) at which you hear your baby by
pressing the up (3) or down (9) buttons on the parent unit. This will not affect the
sensitivity of your baby monitor, only the volume at which you hear those sounds
through the parent unit.
5.2.2.10. TV OUT JACK
The parent unit is supported with TV out jack where you can connect the 3.5mm
A/V standard plug pin.
Locate the TV out jack (2), insert the 3.5mm A/V plug pin and connect to TV
audio/video connector. Make sure your TV setting is in A/V mode. Once the
connection is completed the monitoring display will transfer automatically to your
television.

5.2.2.11. OUT OF RANGE WARNING

When parent unit exceeds the set distance, the parent unit will emit a slow beep
alarm while the LED flashes red.