miniland baby digimonitor 3.5" Bedienungsanleitung Seite 22

· Repeat the above process for 'PAIR' for additional cameras.
· Use the Channel button (27) to check the pictures from different Cameras.
· For Deleting, Push the Channel button (27) at the back for about 3 sec. Press this Channel
button to select the channel to be deleted.
· Then use Adjustment button (+) (-) to choose "DEL". Then press MODE, the deletion
process completed.
LCD On/Off and Power On/Off (25)
When the switch is in the LCD "off" position (the middle position), the Camera is transmitting
whereas there will be no image shown on the Intercom. The unit is using only a small amount
of power and you can still hear the sound signal from the monitored area. Turn the LCD to
"on" position to view the image again and to "off" position to turn the Intercom off completely.
Talk (21)
To talk to the baby, press & hold the Talk button (21) to talk. The talking volume is adjusted
by Adjustment button (13) on baby unit. After talk, release the Talk button & listen to the baby
sound again. Please note that by pressing Talk button, you can remove all icon symbols
display on screen.
Music (23)
Press the Music button (23) once to play the first lullaby broadcast
Press Music button again to change to second lullaby
lullaby 3. Press again to stop lullaby
selection. The LCD will show from
is adjusted by button (13) on the baby unit. The chosen lullaby will play back non-stop until
you stop it.
MODE button (22) & Adjustment button (18)
Brightness, Contrast, Colour,
Press Mode button (22) once, Brightness
the Adjustment button (18) +/-. The same can be done for Contrast
VOX and Volume
If you don't want any sound but a live video image, simply use the Adjustment button to
decrease the volume to zero level. Please note you can also directly press button (18) to
adjust volume level.
Channel Scan
This product enables you to use up to 4 different cameras with the same Intercom
continuously monitoring different areas.
Press Channel button (27) until
entered. The Intercom will remain in each channel for 5 seconds before automatically
switching to the next one & repeating the cycle continually.
To stop Scan function, press Channel button (27) again to return to specific channel number
with corresponding camera.
1 to
sensitivity
.
is appeared on screen. Automatic scanning function is
2. Press again to change to third
. There are three incorporated lullabies for
3 to indicate your selection. The music volume
and Volume can be adjusted by these two buttons.
symbol appears first and it can be adjusted with
22
1on the Baby unit.
, Colour , sensitivity