Language; Engineering Units - bürkert 8175 Bedienungsanleitung

4.4.1 LANGUAGE

The selection of an alternative language is confirmed by the Enter-key and becomes
immediately active.
LANGUAGE
UNIT

4.4.2 ENGINEERING UNITS

The selection of the units will depend on the application and the configuration of the
transmitter via level, distance or volume for fluid measurement.
If the transmitter is to be configured to measure Level or Distance, select the
measuring units and decimal points as required.
If volume is to be selected and configured it is important to note that the
transmitter display within the 'VOLUME TEACH-IN' may not be the measuring
units selected. The conversion of units by the transmitter only applies within
the Volume Teach-In and the table below displays the measuring units selected
and the displayed units which will be used within the Volume Teach-In.
SELECTED MEASURING UNITS
DISTANCE/LEVEL
cm
m
cm
m
cm
m
inch
foot
inch
foot
inch
foot
8175
CALIBRATION MENU
ENTER
0......9
ENTER
VOLUME
l
l
3
m
m 3
US/Imp gal
US/Imp gal
l
l
3
m
3
m
US/Imp gal
US/Imp gal
29
ENGLISH
DEUTSCH
FRANCAIS
ITALIANO
ESPANOL
UNITS USED FOR TEACH-IN
DISTANCE
m
m
m
m
NOT TO BE USED
NOT TO BE USED
NOT TO BE USED
NOT TO BE USED
ft
ft
ft
ft
VOLUME
l
l
3
m
m 3
3
m
3
m
US/Imp gal
US/Imp gal