Description Of The Symbols - Matrix DWS 600-1 Originalbetriebsanleitung

DESCRIPTION OF THE SYMBOLS

The use of symbols in this manual is intended to
draw your attention to possible risks. The safety
symbols and the explanations that accompany
them must be perfectly understood. The
warnings in themselves do not remove the risks
and cannot replace correct actions for preventing
accidents.
This symbol, marking a point of
safety, indicates a caution, warning
or danger. Ignoring this warning can
result in an accident to yourself or
others. To limit the risks of injury, fire
or electrocution, always follow the
recommendations indicated.
Before any use, refer to the
corresponding section in this user
manual.
Conform to applicable safety
standards.
Class II symbol: this machine is
designed with double insulation. It
is not necessary to connect it to an
earthed power socket.
These symbols indicate the requirement of
wearing ear protection, eye protection, respirator
and gloves when using the product.
Recycle unwanted materials instead
of disposing of them. All appliances
and packaging should be sorted
and tendered at a regional recycling
centre into to be processed in an
ecological manner.
residual risks
Even with proper use of the device is always
some residual risk that can not be excluded.
From the nature and design of the device, the
following potential hazards can be derived:
- Contact with the unprotected grinding or
polishing surface (grab / cut injury)
- Ejection of parts of the grinding or polishing
surface (cutting or blunt injury)
- Ejection of parts of the material processed (cut
or blunt injury)
- Contact with sharp edges of the machined
surface (cuts)
- Impairment of hearing, if there is no prescribed
hearing protection is worn (hearing loss)
- Inhalation of particles of abrasive materials and
grinding or polishing surface
If the instructions contained in your instructions
are not observed, other residual risks may arise
due to improper use.
GENERAL SAFETY WARNINGS FOR THE
TOOL
WARNING. Read all safety warnings
and instructions.
Failing to follow the warnings and
instructions can result in an electric
shock, a fire and/or a serious injury.
Keep all warnings and all instructions to be
able to refer to them later on.
The term "tool" in the warnings refers to your
electrical mains powered tool (with power cord)
or your battery operated tool (without power
cord).
GB
15