Using The Accessories - Zanussi ZOP67902XU Benutzerinformation

3. Press or to set the minutes and the
hours for DURATION time.
4. Press to confirm.
When the time ends an acoustic signal sounds for
2 minutes. and time setting flash in the display.
The appliance deactivates automatically.
5. Press any button to stop the acoustic signal.
6. Turn the knob for the oven functions to the off
position.
SETTING THE END
1. Set an oven function.
2. Press again and again until
flash.
3. Press or to set the hours and the
minutes for END time.
4. Press to confirm.
At the set time an acoustic signal sounds for 2
minutes. and time setting flash in the display.
The appliance deactivates automatically.
5. Press any button to stop the acoustic signal.
6. Turn the knob for the oven functions to the off
position.
SETTING THE TIME DELAY FUNCTION
1. Set an oven function.
2. Press again and again until
flash.
3. Press or to set the minutes and the
hours for DURATION time.
4. Press to confirm. The display shows
flashing .

USING THE ACCESSORIES

WARNING! Refer to Safety chapters.
INSERTING THE ACCESSORIES
Wire shelf:
Push the shelf between the guide bars of the shelf
support and make sure that the feet point down.
10
5. Press
minutes for END time.
6. Press
Appliance turns on automatically later on, works for
the set DURATION time and stops at the set END
time. At the set time an acoustic signal sounds for
2 minutes.
The appliance deactivates.
7. Press any button to stop the acoustic signal.
8. Turn the knob for the oven functions to the off
position.
SETTING THE MINUTE MINDER
starts to
Minute minder can be both set when the oven is
turned on and off.
1. Press
flash in the display.
2. Press
the minutes.
When the time you set is longer than 60
minutes,
3. Set the hours.
4. The MINUTE MINDER starts automatically after
5 seconds.
After 90% of the set time the signal sounds.
5. When the set time ends the signal sounds for 2
minutes. "00:00" and
starts to
Press any button to stop the signal.
COUNT UP TIMER
To reset the Count Up Timer, press and hold
and
Deep pan:
or to set the hours and the
to confirm.
and time setting flash in the display.
again and again until
or to set the seconds and than
flash in the display.
flash in the display.
. The timer starts to count up again.
and "00"