Testing - bürkert 8045 Bedienungsanleitung

To access the TEST MENU simultaneously press
2.3

TESTING

See Section 4.5.1
See Section 4.5.2
See Section 4.5.3
See Section 4.5.4
See Section 4.5.4
The actions which are highlighted in grey
measurement.
QUICKSTART
Control of 4 mA
Control of 20 mA
„Flow zero" point
Calibration
Simulation of
the outputs
Enter Fs and Kw
The unit is now ready
6
ENTER
for 5 seconds.
The Offset mode fixes the output
current of 4mA.
The mode Span fixes the output of
20mA.
Put the displayed value at 0.00 in the
selected unit when the liquid in the
pipe is not moving.
This is optional although it is
recommended for commissioning large
systems.
These values enable the calculation of
the process K factor.
must be fully completed for accurate
8045