Installation; Start-Up; Stop - Zummo Z06 Bedienungsanleitung

 The appliance should not be used by people (including children) with limited physical, sensory or
mental capabilities, or lack of knowledge or experience, unless they are properly supervised or
have been given instructions. Children must always be supervised to ensure they do not play with
the appliance.
 This appliance is designed to be used for domestic and analogue use, such as:
-Kitchen areas for the staff of shops, offices and other workplaces;
-Farmhouses;
-Guests in hotels, motels and other residential-type establishments;
-Accommodation environments such as hotel rooms.
3

INSTALLATION

 Attention! The machine weighs 48kg.
accomplished by two persons. The best way to handle a machine is to use one hand to get a grip
underneath the rear and the other placed beneath the squeezing tray. (Fig. 4)
 Place the machine on a sufficiently sturdy and stable base.
Ensure that the machine's voltage and frequency match the values of your electrical installation.

See the identification plate. (Fig. 5)
 Use an electrical outlet that is equipped with an effective earth connection. This outlet should be
used exclusively by the juice extraction machine. Do not plug other appliances into the outlet.
 Before turning on the machine, it is recommended that the pieces that will be in contact with juice
be cleaned first (cups, balls, blade, tray, filter and plastic front).
 Turn on the power switch. (Fig. 6) If no message appears on the display (Fig. 7), this means that
there is a lack of voltage; in this case, make sure that you have plugged the machine into a live
line and that the power switch is turned on. Once this problem has been taken care of, one of the
following three messages will appear: StoP, a number , C
 If the StoP message appears on the display, the machine cannot be started up because the
safety system prevents it. In this case, check the following:
a The cover is properly in place, with its clasps properly fitted inside the slots. (Fig. 8 & 9)
b The tray that holds the squeezer and the blade are properly in place, with the fastening
screws tightened. (Fig. 10)
 If a number or the letter C appears on the display, the machine is ready for normal operation.
4

START-UP

 Once the machine is turned on, the display will show a number between 1 and 50 or the letter C.
The number indicates the quantity of oranges to be squeezed and the letter C means that oranges
will be squeezed without interruption for approximately 30 minutes.
 Depending on the number of oranges that you want to squeeze, keep pressing the SELECT
button and the number on the display will increase from 1 to 50, and then the letter C will appear
(1,2,3,..........48,49,50,C,1,2,3.....). If you keep the SELECT button depressed for more than 3
seconds, the number will decrease.
 Perform this operation until the desired quantity appears.
 Once a quantity is selected and an operation is performed, the machine will store this information
(even if it is shut off) until a new selection is made.
 When the ON button on the panel is pressed, the machine will squeeze the number of oranges
shown on the display. During the process, the number of oranges left to squeeze will appear on
the display. If you want to repeat the operation, simply press the ON button. To stop the process,
press the STOP button.
5

STOP

With the machine running, press the StoP button. On the display a 0 will appear and the machine will
stop when the cups reach the vertical position. Afterwards, the display will show the number of the
previous selection.
12
When moving machine, we suggest that this be