Changing The Engraving Point; Engraving - Parkside PGG 15 D3 Originalbetriebsanleitung

Note: Take care when increasing the cutting depth not to turn
the stroke rate rotary controller
Otherwise the switch could screw off the product.

Changing the engraving point

CAUTION! RISK OF INJURY!
Switch the product off and pull the plug out of the mains
socket before carrying out any work on the product.
Change the engraving point
and no longer delivers the desired results. Turn the engraving
point holder
can be removed.
Note: Such engraving points are available from speciality
retailers.
Remove the spring and the plain washer.
Note: Spring is under pressure.
Push the plain washer and spring onto a new engraving point
. Then insert this and turn the engraving point holder
5
clockwise until it is firm to lock the engraving point in position.
Ensure that the engraving point

Engraving

You can use this product to create attractive and unique engrav-
ings. For example, you can use it to mark valuables as your own.
You can engrave numbers and letters into metal, glass, wood,
36 GB/IE
counterclockwise until the engraving point
6
too far towards the + sign.
2
as soon as it gets worn down
5
is well secured.
5
6