Krups EA894 EVIDENCE PLUS Bedienungsanleitung Seite 37

Cleaning program for the "One Touch Cappuccino" block
Cleaning the "One Touch Cappuccino' block allows you to fight against milk deposits and ensures the best possible
hygiene.
To perform this cleaning you will need:
- 1 dose of KRUPS cleaning liquid.
- 1 container of a minimum of 600 ml.
- Press the Settings button
- Select Maintenance.
- Then Milk Cleaning.
- Let yourself be guided by the instructions on the screen.
Removing the "One Touch Cappuccino" block
In addition to the rinsing it is necessary to clean the different elements of the block after each use. To remove the block
follow the following instructions:
- Remove the milk tube Fig. 21
- Remove the front cover of the "One Touch Cappuccino" removable block by sliding it down and pulling it toward
you. Fig. 22
- Remove the "One Touch Cappuccino" block by pulling on the upper part of the block. Fig. 23
- Completely dismantle the block. Fig. 24
- Remove the connector of the milk tube. Fig. 25
- Clean all of the dismantled parts (block, connector and milk tube) in soapy water. Then rinse them under hot
water. Fig. 26
- Once the elements are cleaned and dried, assemble the block. Put it back in its original position. Fig. 27
- Reposition the front cover of the removable "One Touch Cappuccino" block.
- Replace the connector in the milk tube. Fig. 29
- Reconnect the milk tube to the "One Touch Cappuccino" removable block". Fig. 30
Automatic descaling program of the steam circuit:
Descaling your machine ensures its proper functioning and eliminates any deposit of limescale or tartar that can influence
the taste of the coffee.
The frequency at which this program is run depends on the quality of the water used and whether a Claris Aqua Filter
System filter cartridge is used or not. The more limescale from your water, the more often the descaling has to be carried
out.
!
Warning: If your device is equipped with our Claris cartridge Aqua Filter System cartridge please remove it before
the descaling procedure.
To perform this cleaning you will need:
- 1 dose of KRUPS descaler
- 1 container of a minimum of 600 ml
The cycle will link two phases:
- 1 descaling phase
- 1 rinsing phase
st
- 2 rinsing phase
nd
When do I run this program?
When you need to carry out descaling, your device will notify you.
- Fill the water tank up to the CALC mark.
- Pour the dose of descaler into the water tank.
- Press to start the descaling program.
- To postpone it press
- Then let yourself be guided by the instructions on the screen.
!
Important: You do not have to run the cleaning program as soon as the appliance requests it, but you must do it
reasonably soon after. If the cleaning is postponed the alert message will remain displayed as long as
the operation has not been performed.
.
.
(approximatly 5 minute)
(approximately 20 minutes)
35