Installing The Microphone; Mounting On The Sun Visor; Installation On The Steering Column - Pioneer AVH-A7100BT Installationsanleitung

Dashboard
Mounting sleeve
Side bracket
Screw (2 mm × 3 mm)
DIN Rear-mount
1
Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
When installing in a shallow space, use
the following screw holes.
Use binding screws (4 mm × 3 mm)
only.
2
Tighten two screws on each side.
Use any of binding screws (4 mm × 3
mm), binding screws (5 mm × 6 mm) or
flush surface screws (5 mm × 6 mm),
depending on the shape of screw holes
in the bracket.
Screw
Dashboard or console
Factory radio mounting bracket
NOTE
In some types of vehicles, discrepancy may
occur between the unit and the
dashboard. If this happens, use the
supplied frame to fill the gap.
Removing the unit
Extend top and bottom of the trim ring
outwards to remove the trim ring. And
then loosen the screws (2 mm × 3 mm) to
remove the mounting sleeve.
• When reattaching the trim ring, push the
trim ring onto the unit until it clicks. (If
the trim ring is attached upside down,
the trim ring will not fit properly.)
Mounting sleeve
Screw (2 mm × 3 mm)
Trim ring
Installing the
microphone
• Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver's
voice.
• Be sure to turn off (ACC OFF) the product
before connecting the microphone.
• Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.
Mounting on the sun
visor
1
Fit the microphone lead into the
groove.
Microphone lead
Groove
2
Attach the microphone clip to the sun
visor.
Microphone clip
Clamps
Use separately sold clamps to secure
the lead where necessary inside the
vehicle.
Install the microphone on the sun visor
when it is in the up position. It cannot
recognise the driver's voice if the sun
visor is in the down position.
Installation on the
steering column
1
Detach the microphone base from the
microphone clip by sliding the
microphone base while pressing the
tab.
Tab
Microphone base
2
Mount the microphone on the
steering column.
En
7