Playing Along With The Metronome; To Sound The Metronome; Changing The Metronome Settings - Korg HT-70 Bedienungsanleitung

Playing along with the metronome

It's convenient to use the metronome when you want to play to an accurate tempo.

To sound the metronome

1. Press the [
The [
2. To stop the metronome, press the [
The [

Changing the Metronome Settings

Settings described here (with the exception of tempo and time signature) are retained even
while the power is off. When you press [
writes the new value into nonvolatile memory. During this time, the multidisplay will indicate
that writing is in progress (
Do not turn the HT-70 power off while writing is in progress. Doing so may cause loss or cor-
ruption of memorized settings and song data.
Changing the Tempo Setting
1. Hold down [
The switch begins flashing.
2. The TEMPO indicator LED (next to the [DISPLAY] switch) comes on, and the multidis-
play shows the current tempo setting.
If the TEMPO indicator LED does not come on, press [TEMPO (■)].
3. Use [▲] or [▼] to set the desired tempo.
Press briefly to change the value by 1, or hold the switch down to change continuously.
If you wish to reset the tempo to its factory default, press [▲] and [▼] at the same time.
The available range is ( =) 4 to 250.
4. When you have made set the value, press [
The HT-70 returns to its previous state. The [
or else comes on solid).
12
] switch.
] switch will light.
] switch will go dark.
☞p.5
).
] for at least one second.
1, 2
] switch once again.
] after making each change, the HT-70 automatically
3
2
3 1, 4
] again.
] switch stops flashing (either goes off