Sony BVP-900 series Bedienungsanleitung Seite 13

@¡ MIX VF (mix viewfinder) switch
Selects the picture in the viewfinder when the RET 1
or RET button is depressed.
ON: When the RET 1 or RET button is depressed, the
mixed picture of the camera output signal and the
return video signal (return video 1 or the return
video signal selected at the RETURN SELECT
knob) can be monitored on the viewfinder screen.
The mixing ratio can be adjusted with the control
on the internal board of the CCU-700A/700AP.
For details, refer to the System Manual.
OFF: Only the return video 1 or the return video
signal selected at the RETURN SELECT knob can
be monitored when the RET 1 or RET button is
pressed.
@™ UP TALLY switch
Selects whether to make the external tally lamp, up
tally lamp or front tally lamp on the viewfinder lit
when a red tally signal is supplied to this camera
system.
ON: The tally lamps light.
OFF: The tally lamps do not light.
You can adjust the brightness of the up tally lamps on
the BVP-900/900P and the viewfinder.
For details, refer to the System Manual.
@£ SAFETY ZONE switch
ON: A box (safety zone) indicating 90% of the picture
appears on the viewfinder screen.
OFF: A safety zone does not appear on the viewfinder
screen.
You can change the size of the safety zone to 80%
with a switch on the BVP-900/900P.
For details, refer to the System Manual.
@¢ CENTER MARKER switch
ON: A white cross (center marker) indicating the
center of the viewfinder screen appears on the
viewfinder screen.
OFF: A center marker does not appear on the
viewfinder screen.
You can adjust the position of the center marker to the
center of the lens to be used. The adjusted position can
be stored in a lens file.
For details, refer to the System Manual.
@∞ CC (color temperature conversion) filter control
Selects a filter suitable for the lighting conditions when
the FILTER LOCAL button is lit.
Position Filter
A Cross filter
B 3200K (Clear)
C 4300K
D 6300K
E 8000K
@§ Spare switch
@¶ ND filter control
Selects the ND filter when the FILTER LOCAL button
is lit.
Position Filter
1 Clear
1
2 / ND
4
1
3 / ND
8
1
4 / ND
16
1
5 / ND
64
@• FILTER LOCAL (filter local control) button
Press and light up this button to enable switching the
CC and ND filters using the CC and ND filter controls.
Press this button again so it goes out to return filter
control to the master setup unit or remote control
panel.
@ª VF (viewfinder) connector (D-sub 25-pin)
Connect to the camera connector on a viewfinder.
#º Memo clip
#¡ MIC (intercom microphone) ON/OFF switch
Turns the headset microphone on or off.
#™ INTERCOM PROD/ENG (intercom producer/
engineer line) switch
Selects the destination of the intercom 1 or 2 signals
between the producer line and engineer line.
PROD: Goes to the producer line.
ENG: Goes to the engineer line.
11 (E)