Kruger KRS 320 Bedienungshandbuch Seite 43

• Make on the wall nr. 4 x Ø8 holes deep 45 mm as indicated in pic. 4;
• clean the inside of the holes;
• Insert the four screw plugs supplied keeping the fins on the vertical plain.
• Fasten the bracket using the four supplied screws
S
In order to respect the minimum distance C of pic. 3, the holes must be made at least 720 mm from
the ground.
Removing the hood
To remove the hood of dehumidifier do the following, referring to pic. 5:
• remove the two side screws V which block the bodywork;
• pull from the bottom to release the two lower locks of the mantle;
• lift the hood and lay it on the ground.
At this point you can access the inside of the machine to perform the required operations.
M1097-0_draft-1
Pic.3 – Holes and wall bracket positioning
Pic.4 – Opening of the hood
ENGLISH
gb-43