Initial Use; Setting Up The Appliance - NEFF C1.KS61H0-Serie Gebrauchsanleitung

E
Touch E to open the selection of service
programmes. Run the desired programme
as described in the section "Service
programmes".
Double G
Touch G after selecting a drink to
prepare two cups simultaneously (see the
section "Two cups at once").
My Coffee B
Touch B to open the selection of "Per-
sonalised beverage preparation". Personal
settings for coffee drinks can be saved and
called up (see the section "Personalised
drinks").
C
Touch C for either beverage preparation
or to launch a service programme.
If you touch C again while the drink is
being prepared, dispensing will be prema-
turely halted.
Arrow navigation button
Press the arrow on the arrow button to navi-
gate in the display or to change parameters.
Display
The display shows drinks, settings and
information (see the section "Display").

Initial use

General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans. Do not use coffee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit.
A
Before the appliance can be
switched on and used, it must
be assembled and connected
according to the enclosed assembly
instructions.

Setting up the appliance

■ Remove any protective plastic film.
F
Important: Only use the appliance
in a frost-free room. If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use.
■ Take hold of the appliance door by the
recessed grip and open.
■ Remove the water tank, rinse it and fill it
with fresh water up to the "max." mark.
■ Replace the water tank and click into
place.
■ Remove the bean container, fill with
coffee beans and replace.
■ Set the mains switch to I and close
the appliance door.
The appliance heats up and is rinsed.
The display is activated.
"Please set your preferred language."
appears.
■ Press the M arrow button. The field
"Deutsch" has a light background. The
language can be changed.
■ With the L arrow button select the
desired language.
■ Press the N arrow button. The field
"Language" has a light background.
■ Select the "Water hardness" with the L
arrow button.
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run.
The preset water hardness is level
4.If a water softener is installed in
the house, please set the water hard-
ness to level 3. You can also check
the water hardness by asking your
local water supplier.
■ Use the enclosed test strip to determine
the water hardness. Briefly dip the test
strip in water and check the result after
one minute.
Initial use en
37