Specifications; Additional Safety Rules - Makita 9741 Betriebsanleitung

ENGLISH
Hex wrench
Spindle
Wheel
Hex wrench
Output shaft
Notch
Pin

SPECIFICATIONS

Model
Wheel size (Diameter x Width) ......100 x 120 mm
No load speed (RPM) ..................................3,500
Dimensions (L x W x H) ....... 310 x 185 x 182 mm
Net weight ...................................................4.2 kg
• Due to the continuing program of research and
development, the specifications herein are sub-
ject to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a
power supply of the same voltage as indicated on
the nameplate, and can only be operated on sin-
gle-phase AC supply. They are double-insulated
in accordance with European Standard and can,
therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to enclosed
safety instructions.

ADDITIONAL SAFETY RULES

1. Inspect for and remove foreign matter
such as nails, screws, etc. from the work-
piece surface before operation.
2. Secure the workpiece firmly.
3. Do not wear gloves during operation.
4. Hold the machine firmly with both hands.
5. Keep hands away from rotating parts.
6. Do not leave the machine running. Operate
the machine only when hand-held.
7. Never attempt to use with the machine
held upside down in a vise, etc.
SAVE THESE INSTRUCTIONS.
Explanation of general view
Wing nut
Front roller
Cover plate
Dust port
Joint
Switch trigger
OPERATING INSTRUCTIONS
9741
Removing or installing wheel (Fig.1 &2)
Important:
Always be sure that the machine is switched off
and unplugged before removing or installing the
wheel.
To remove the wheel, insert one hex wrench into
the end of the spindle and another hex wrench
into the end of the output shaft. Turn the hex
wrench in the output shaft clockwise while
securely holding the hex wrench in the spindle so
that the wheel cannot revolve. Pull the output
shaft out of the wheel. Move the wheel slightly
away from the spindle and remove the wheel
from the machine.
NOTE:
The output shaft has a left hand thread.
To install the wheel, follow the removal proce-
dures in reverse. When installing it, be sure to
align the notches in the wheel with the pins on the
spindle.
Adjusting front roller (Fig. 3)
The front roller allows you to apply uniform pres-
sure to the workpiece. To adjust the front roller,
set the machine on a flat surface and loosen the
wing nut.
Adjust the front roller up or down until the clear-
ance distance (D) is about 2 mm. Tighten the
wing nut securely.
Connecting to dust collector (Fig. 4)
The use of a dust collector makes sanding opera-
tions clean and dust collection easy. To connect a
dust collector, open the dust port by sliding the
cover plate up and in a clockwise direction.
Attach the joint onto the dust port. Now a dust
collector can be connected to this machine.
CAUTION:
When not using a dust collector, close the dust
port opening with the cover plate.
Lock button
Grip
Handle
Limit mark
Screwdriver
Brush holder cap
5