Safety Hose - ETNA VWV549WIT Anleitung

INSTALLATION

Safety hose

EN 24
The safety hose is double-walled. The system automatically cuts off
the water supply if the water inlet hose starts to leak and the space
between the walls is filled with water.
• Use new hoses to connect the appliance. Do not use hoses that
have alredy been used.
• The water pressure must be between 0,04 MPa and 1 MPa. If the
pressure is less than 0,04 MPa, contact the service department.
Connecting the safety hose
• Pull the safety hose completely out of the housing at the back of
the dishwasher.
• Connect the hose to a faucet with ¾ inch screw thread.
• Make sure the faucet is fully open before using the dishwasher.