Connecting The Air Hose - JUKI LK-1942 Betriebsanleitung

(12) Managing the cord
1) In the state that the sewing machine is tilted, connect the cords, and bundle them with clip band 1 as
shown in the figure.
2) Fix the cords with cords setting plate 2 in the state that the cords slacken as shown in the figure.
When you tilt the sewing machine, make sure that the sewing machine head support
bar is placed on the table.
1

(13) Connecting the air hose

4
3
5
7
8
14
2
1) Cut the air tube supplied with the machine in an
appropriate length, and connect solenoid vsalve 1 with
1
air regulator 2.
2) Connect the air source hose using one-touch joint 3 and
hose band 4 supplied with the machine.
3) Open air cock 5 and adjust the air pressure to 0.5 to
0.55 MPa {5 to 5.5 kgf/cm
adjustment knob 6 of the air regulator while observing
air pressure gauge 7.
4) Turn knob 8 located in front of the air regulator using a
small screwdriver and adjust the pressure switch to 0.4
MPa {4 kgf/cm
6
2
2
} by pulling up and turning
2
}.
Slack