Auto Off Function; Hints And Tips; Preparing The Laundry - Electrolux EDH3497RDW Benutzerinformation

CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.2 Starting the programme with
delay start
1. Set the correct programme and op-
tions for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
• You can delay the start of a pro-
gramme from a minimum of 30 mi-
nutes to a maximum of 20 hours.
3. Press the Start/Pause touchpad, the
countdown starts. The display shows
the countdown of the delay start.
• When the countdown is completed,
the programme starts.

7.3 Auto Off function

To decrease the energy consumption, this
function automatically deactivates the ap-
pliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the pro-
gramme.
7.4 Change a programme
1. Press the on/off button to deactivate
appliance

8. HINTS AND TIPS

8.1 Preparing the laundry

• Close the zippers.
• Close the fasteners of the duvet covers.
• Do not keep ties or ribbons loose (e.g.
apron ribbons). Tie them before you
start a programme.
• Remove all items from the pockets.
• If an item has the internal layer made of
cotton, turn it inside out. Make sure that
the cotton layer is always external.
2. Press the on/off button to activate the
appliance.
3. Set the programme.
7.5 At the end of the
programme
When the programme is completed,
• An intermittent acoustic signal oper-
ates.
• The indicator
is on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is al-
most completed or completed.
When the crease guard phase is comple-
ted:
• The indicator
is on.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate
the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty
the water container when a pro-
gramme is completed.
• We recommend that you set the cor-
rect programme applicable for the type
of fabrics that are in the appliance.
• Do not put fabrics with strong colours
together with fabrics with light colours.
Strong colours can bleed.
• Use an applicable programme for cot-
ton jersey and knitwear to prevent the
items to shrink.
• Make sure that the laundry weight is
not more than the maximum weight
that is in the programme table.
ENGLISH 27