Commissioning The Device - ProMed NRP-5.4 Gebrauchsanleitung

COMMISSIONING THE DEVICE

Please check that the scope of delivery is complete before commissioning the device.
Ensure that the heating pad is not jammed.
Only use original parts!
Do not use any other operating unit!
Caution
Please ensure that the heating pad is attached loosely so that some air can circulate between
the heating pad and your skin.
Prevent heat accumulation at all costs.
WARNING – Risk of burning
• A prolonged use of the device at its highest settings can lead to burn injury
• To prevent burn injury to the skin, test the temperature of the device with the back of your hand before
using it (do not use the palm of your hand since it is less sensitive than other body parts).
• Do not put the heating pad directly onto your skin. Only use it on your clothing.
DE
Note:
A slight smell can develop when heating up the device for the first time. This is harmless. If applicable,
EN ensure that it is sufficiently ventilated.
1. Remove the protective film from the display of the control unit.
FR
2. Check if both plugs (plug of the operating unit (G) and socket of the neck
and back heating pad (H)) are connected to each other. If this is not the
case, please ensure that they are correctly connected.
3. Put the heating pad on your back and the collar over your shoulders, while the plug
IT
of the operating unit (G) is directed to the outside. Fix the push buttons (J) and the hip
belt (I) so that the heating pad stays in position.
4. Insert the mains plug (A) into the socket. The On/Off LED (D) is illuminated and "8"
ES
appears on the display (E); both go out after approximately 1 second.
5. Press the On/Off button (F) in the display to switch on the neck and back heating pad.
"1" appears.
NL
6. Press the temperature button (E) to set the desired temperature. You can set the desired
temperature in 4 steps). Press the temperature button (E) again to increase the desired temperature.
Once you have achieved the highest level "4", the settings start again at "1" by pressing it again.
After a few minutes, the heating pad should have reached its maximum temperature. Now you can
RU
switch back to a lower heating level.
Note:
PL
The heating pad is equipped with a safety regulator, which regulates the heat and prevents the device
from getting too hot.
7. If you do no longer wish to use the heating pad, press the On/Off button (F) to switch off the heating
SE
pad and pull the plug out of the socket. Always pull at the plug, not the cable.
Automatic switch-off
After 90 minutes, the heating pad switches off itself. The ON/Off LED (D) is illuminated.
AR
• Activate / deactivate the heating pad with the On/Off button (F).