Solution Filter Cleaning; Charging The Batteries - Nilfisk-Advance BA 600S Bedienungs- Und Wartungsanleitung

USER MANUAL

SOLUTION FILTER CLEANING

1. Drive the machine on a level ground.
2. Check that the ignition key (10, Fig. B) is to "0" position.
3. Operating on the right lower side of the machine, close
the solution tap (5, Fig. F). The tap (5) is closed when it
is on the position (6) as to the hoses; it is open when it is
on the position (7).
4. Operating on the left lower side of the machine (at the
"FILTER" mark), remove the transparent cover (1, Fig. F)
and the wire gauze (2); clean and reinstall them on the
support (3).
NOTE
The wire gauze (2) must be correctly
positioned on the support (3) housing (4).
5. Reopen the tap (5, Fig. F).

CHARGING THE BATTERIES

NOTE:
Charge the batteries when the yellow and the
red warning lights (9b or 9c, Fig. B) turn on, or
at the end of each cleaning.
CAUTION!
Keeping the batteries charged make their life
last longer.
CAUTION!
When the batteries are discharged, charge
them as soon as possible, as that condition
makes their life shorter.
Check for battery charge at least once a week.
CAUTION!
Use a battery charger suitable for the type of
batteries installed.
WARNING!
Lead/acid battery charging produces highly
explosive hydrogen gas. Charge the batteries
in well-ventilated areas and away from naked
flames.
Do not smoke while charging the batteries.
While charging the battery, always keep the
tank assembly open.
16
WARNING!
Be extremely careful when charging the
batteries as there may be battery fluid
leakages. The battery fluid is corrosive. If it
comes in contact with the skin or eyes, rinse
thoroughly with water and consult a physician.
1. Drive the machine on a level ground.
2. Turn the handwheel (3, Fig. J) counter-clockwise until
the tank assembly is released.
3. Carefully lift the tank assembly (4, Fig. J) with the
handlebar (2, Fig. C).
4. For lead batteries only:
– check the electrolyte level inside the batteries (8, Fig.
J); if necessary top up through the caps (9);
– leave all the caps (9) open for next charging;
– clean (if necessary) the upper surface of the
batteries.
5. Charge the batteries according to one of the following
procedures, depending on the presence of the electronic
battery charger (1, Fig. E).
Charging the batteries with an external battery
charger
1. Check that the battery charger is suitable by referring to
the Battery Charger Manual.
The battery charger voltage rating is 24V.
2. Disconnect the battery connector (30, Fig. C) and
connect it to the external battery charger.
3. Connect the battery charger to the electrical mains.
4. When the recharging is complete, disconnect the battery
charger from the electrical mains and from the battery
connector (30, Fig. C).
5. (For lead batteries only) Check the level of electrolyte
inside the batteries and close all the caps (9, Fig. J).
6. Reconnect the battery connector (30, Fig. C) to the
machine.
7. Carefully lower the tank assembly (4, Fig. J) with the
handlebar (2, Fig. C).
8. Turn the handwheel (3, Fig. J) clockwise until the tank
assembly is locked.
9. When the tank (4, Fig. G) has been filled, the machine is
ready to be used (see the related paragraph for the
procedure).
909 5319 000(3)2005-01 A