Intended Use - Worx WX253 Originalbetriebsanleitung

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.

INTENDED USE

The power tool is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE OPERATING THIS TOOL
A) CHARGE THE BATTERY
The battery charger supplied is only for the Li-Ion battery
installed in the machine. Do not use another battery
charger.
The Li-Ion battery is protected again st deep discharging.
When the battery is empty, the machine is switched off by
means of a protective circuit: The tool holder no longer
rotates.
12
When the Battery Pack is charged for the first time or after
prolonged storage, the Battery Pack will accept a 100%
charge after several charge and discharge cycles.
B) CHARGING (See Fig. A)
Plug the charger plug into a suitable power outlet. Next,
connect the screwdriver to the Charging Socket; the
indicator will illuminate Red during charging.
Let the battery charge for 3-5 hours. The battery is fully
charged as soon as the indicator is no longer lit. Then
unplug the charging, Disconnect the Charger from the
screwdriver. The screwdriver is ready to be used.
IMPORTANT: When charging, the charger and
screwdriver may become warm to the touch; this is normal
and does not indicate a problem.
2. OPERATING INSTRUCTIONS
Inspect the Screwdriver before using to ensure all the parts
are running smoothly and there are no abnormal sounds
or sparks. Before driving fasteners, check behind walls for
wire and other electrical hazards or plumbing.
OPERATION
1. INSERTING THE BIT CARTRIDGE (See Fig. B)
Pull the Cover back completely to insert the Bit Cartridge.
2. SELECTING A BIT
Pull the Cover back completely. Manually rotate the Bit
Cartridge to left or right to find the proper bit. Push the
Cover forward and make sure it is completely closed (See
Fig. C1, C2).
If the bits in the Bit Cartridge need to be replaced,
remove Bit Cartridge by pushing it up from the window
underneath. Replace the bits with the desired bits.
Ensure the bits are properly positioned in the Cartridge
and are not protruding from the back of the Bit Cartridge.
Or, simply pull a bit from the holder, and replace it with
the desired bit. It will load into the Cartridge automatically
when the cover is opened (See Fig. D).
NOTE:
1. Only 25mm bits are compatible with the screwdriver.
2. If the Cover is not open fully, the Bit Cartridge will
get stuck when taking it out from the tool. Pull the
cover all the way back.
3. The cover may not fully close if the bit cartridge
is not properly aligned inside. Make sure the bit
cartridge has clicked into place when selecting the
desired bit to use. If the cover cannot properly close,