3.1
1. Insert the power supply unit plug into the connection
Using with
unit.
the power
2. Plug in the power supply unit.
supply unit
3. Place the massager around the neck so that it has sufficient hold on the
shoulders.
4. Press the MASSAGE button
appliance starts working straight away at high intensity. Press the MAS-
SAGE button
Press the MASSAGE button
5. Press the HEAT
cator lights up. To switch the heat function off, press the HEAT
again.
6. Guide your hands through the hand straps
pulling on the straps you may stabilize the device in its position and
adjust the massage intensity (pulling more stronger increases the mas-
sage intensity)
7. After 15 minutes of constant use the device will switch off automatically.
NOTE
The massage intensity declines when the heat function is
switched on.
3.2
Changing the batteries
Using with
Undo the zip on the back of the appliance to get into the battery compart-
batteries
ment
(1.5 V, type AA LR 6).
Remember to insert the batteries as indicated in the diagram in the battery
compartment. Replace the battery compartment lid and do the zip up again
carefully.
WARNING - BATTERY SAFETY INFORMATION
•
•
•
•
•
•
twice to change to massage intensity to a lower level.
5
button to switch on the heat function. The LED indi-
4
. Remove the lid of the battery compartment. Insert four batteries
1
Do not disassemble batteries!
Clean the battery and device contacts if necessary before put-
ting in the batteries!
Remove discharged batteries from the device immediately!
Increased risk of leakage, avoid contact with skin, eyes and
mucous membranes! If battery acid comes in contact with any
of this parts, rinse the affected area with copious amounts of
fresh water and seek medical attention immediately!
If a battery has been swallowed seek medical attention imme-
diately!
Replace all of the batteries simultaneously!
, to switch on the massage function. The
5
once again to switch the appliance off.
5
on right and left side. By
2
3 Operating
on the control
3
button
4
GB
17