Technical Data; Noise Emission Values; Before Starting The Equipment - EINHELL BT-UP 470 Originalbetriebsanleitung

Anleitung_BT_UP_470_SPK7:_
GB
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

AC motor
Power P
Idle speed n
0
Carbide saw blade
Number of teeth
Cutting height max.
Dust extraction connector
Weight
Protection class:

Noise emission values

Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Vibration emission value a < 2.5 m/s
h
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Reduce noise generation and vibration to a
minimum!
Use only equipment that is in perfect condition.
Maintain and clean the equipment regularly.
Adopt your way of working to the equipment.
Do not overload the equipment.
Have the equipment checked if necessary.
Switch off the equipment when not in use.
16
10.11.2009 15:48 Uhr

6. Before starting the equipment

Unpack the saw and check it for damage which
may have occurred in transit.
The equipment has to be set up where it can
stand securely.
All covers and safety devices have to be properly
fitted before the equipment is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws, etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
equipment's moving parts run smoothly.
230 V ~ 50Hz
Check that the voltage on the rating plate is the
860 W
same as your supply voltage before you connect
the equipment to the power supply.
11,000 min -1
Ø 127 x Ø 17 x 2.5 mm
14
7. Assembly
18 mm / 0°
Important. Pull out the power plug before
Ø 36 mm
carrying out any maintenance, resetting or
7.6 kg
assembly work on the circular saw!
II /
7.1 Setting up the saw (Fig. 4-7)
Insert the plastic feet (7) into each corner of the
housing. Secure the feet with the supplied screws,
springs and washers. Tighten the screws. Attach the
rubber pieces to the feet. Secure the handle (3) to the
equipment using the supplied screws. Tighten the
screws.
Operation
7.2 Changing the table insert
96 dB(A) To prevent increased likelihood of injury the table
insert (13) should be changed whenever it is worn
3 dB
or damaged.
109 dB(A)
Remove the screws.
Lift the worn table insert (13) up and out.
3 dB
To fit the replacement table insert, proceed in
reverse order.
2
7.3 Changing the saw blade (Fig. 8-13)
Important. Pull out the power plug.
Wear work gloves when changing the saw blade.
Use the knurled handle (4) to lock the equipment
at the guide rail (6).
Unscrew the screw from the saw blade cover
(17).
Then press the spindle lock (19). Turn the saw
blade screw (20) anticlockwise with the supplied
hexagon wrench (18).
Remove the screw (20), washer (21) and the
external flange (22). The saw blade (14) will drop
Seite 16