Isdn Terminals At The Internal S0 Port - Auerswald COMmander 6000RX Betriebsanleitung

Installation
must be laid fixed. A wall socket (RJ-11 or, within Germany, TAE) is connected with the
terminal clamps of the internal analogue port as shown in the figure.
ISDN Terminals at the Internal S
Connection possibilities:
• COMfortel 1200/1400/1600/2600 system phones (as of firmware version 1.6A or later)
• COMfortel 1100/1500/2500/2500 AB system phones (as of firmware version 4.4E to 6.4)
• COMfortel DECT 900 Bases for COMfortel DECT 900C/900
• ISDN phones in accordance with the Euro ISDN Standard (DSS1)
• ISDN PC controllers in accordance with the Euro ISDN Standard (DSS1)
Important: For COMfortel 1400/2600 with answering machine: In order to ensure the full
scope of functions, you should connect only 1 phone per port.
Requirements:
• Enabled operating mode "S
• Enabled terminators in the PBX at the internal S
two directions)
operating mode "S internal"
0
If PBX and terminal have a short
distance to each other, make the
connection with an ISDN cable
(max. 10 m) at the RJ-45 sockets of
the internal S port.
0
If the distance between PBX and
terminal is greater, cables and wall
sockets must be laid fixed. A socket
wall is connected with the terminal
clamps of the internal S
shown in the figure.
68
Port
0
internal" at the S
0
port as
0
port in question
0
port in question (exception: bus wiring in
0
terminators enabled
internal S port
0
IAE/UAE8
terminators
100 ohm, 0.25 W
COMmander 6000/R/RX - Instructions V11 11/2018