Remedy Of Faults - Oase biOrb LIFE Gebrauchsanleitung

- EN -
Installing and connecting the air stone pump
N O T E
When installing the unit, ensure that it
• is located outside the aquarium
• is not placed on or over the aquarium
• cannot fall into the water or move out of position.
Damage resulting from incorrect installation is not ba-
sis for a claim within the framework of the guarantee
or warranty.
How to proceed:
 D
1. Connect the air hose leading out of the aquarium to
the air connection of the air stone pump and fit the
air stone pump above the subsequent level of the
aquarium water.
– This prevents water from leaking or damage to
the pump in case the integrated non-return valve
should fail.
2. Connect the connection cable of the air stone pump
to the separate socket of the plug-in transformer so
that it forms a drip loop.
– Always connect the air stone pump to the plug-in
transformer first, then connect the plug-in trans-
former to
(→ Commissioning/start-up)
Connecting the lighting unit
• See the separately included operating manual.

REMEDY OF FAULTS

Malfunction
The water becomes soiled within a
short time.
Air stone pump doesn't start up.
Air stone pump is noisy.
Fewer air bubbles in the air tube than
normal
The air stone pump is noisy and there
are still fewer air bubbles even after
replacement of the air stone.
18
the power socket.
Cause
The filter cartridge is exhausted.
Overfeeding
Too many fish
No mains voltage
Air stone pump defective
Air stone pump is vibrating.
Air stone is exhausted.
The air stone pump is only functioning to a
limited extent.
COMMISSIONING/START-UP
Filling with and preparing the water
It is necessary to prepare the aquarium water by add-
ing "Water Conditioner" and "Biological Booster".
How to proceed:
 E, F
1. Fill the aquarium with 2 litres of tap water.
2. Insert the plug-in transformer into the socket to
switch on the air stone pump.
3. Fill the aquarium with more tap water up to about
5 cm below the cover.
4. Cut open the "Water Conditioner" bag and sprinkle
the contents into the water.
5. Once the pump has been running for at least 24 h,
sprinkle the contents of the "Biological Booster" bag
into the water.>
Switching the air stone pump on/off
N O T E
Never operate the air stone pump by itself, i. e. with-
out the bubble tube and air stone stone.
How to proceed:
 F
Switching on: Connect plug-in transformer to the
socket. The unit switches on immediately when the
power connection is established.
Switching off: Disconnect the plug-in transformer.
Switching the lighting unit on/off
• See the separately included operating manual.
Remedy
Replace the filter cartridge.
Reduce the amount of food.
Reduce the number of fish.
• Check the connection of the air stone pump at
the transformer
• Check the mains voltage.
Replace the air stone pump.
Place the air stone pump onto a softer sur-
face.
Replace the air stone.
Replace the air stone pump immediately.
biOrb CLASSIC / FLOW / CUBE / LIFE / TUBE