Power Supply; Replacing Batteries - JDSU OLS-34 Bedienungsanleitung

3 G
ETTING

Power supply

The following power sources can be used to operate the
OLS-34/-35/-36:
• two 1.5 V dry batteries
(Mignon AA size, alkaline type recommended)
• two 1.2 V NiMH rechargeable batteries
(Mignon AA size)
• via the AC adapter
Battery operation
CAUTION
!
Please note the battery operation safety information in
the chapter "Battery operation" on page 8.

Replacing batteries

!
Do not replace individual batteries. Always change all
two batteries at the same time.
!
Always use two batteries of the same type; i.e. do not
mix rechargeable and non-rechargeable batteries.
Replacing batteries
The battery compartment is on the back of the
instrument.
1. Pull down the lid to open the battery compartment.
2. Fit new batteries or remove the used batteries and
replace them with fresh ones.
NOTICE: Take care to insert the batteries correctly. The
correct polarity is indicated by a diagram
inside the battery compartment.
3. Close the battery compartment.
*
4. Press [ ] to switch on.
Note: The batteries can not be recharged with the
OLS-34/-35/-36.
14
S
TARTED
Dangers when handling batteries
Handling batteries may be dangerous.
Please note the following safety
instructions.
OLS-34/-35/-36 JDSU