Cleaning The Rinsing Pump; Replacing The Rinsing Pump - Oase ProfiClear Premium TF-L gepumpt EGC Gebrauchsanleitung

2. Undo and remove both Allen screws (width across flats 5), pull the drum motor out of the hole in the
separating plate and remove.
– Do not allow the drum motor to hang from the connection cable.
3. Undo the hose clip fastening the dirt channel.
4. Pull the dirt channel from the socket of the dirty water outlet and take it out of the filter drum.
5. Open the cotter pin and pull it out.
6. Pull out the drum shaft.
7. Pull the filter drum from the separating plate and lift it out of the container.
– Proceed carefully: The fastening clips on the container wall could damage the screen elements.
Fitting
How to proceed:
 X
Before fitting the filter drum check that the drum seal is undamaged and correctly positioned. Replace the
drum seal if damaged.
1. Fitting a new drum seal: Ensure that the recess in the drum seal is at the top.
2. Ensure that the separating plate is completely seated in the groove of the drum seal.
3. Grease the edge of the drum to improve the smooth movement of the filter drum.
– Only use original grease (Turmsilon GTI 300 GK) from OASE.
 W
► Continue to assemble in the reverse order.
9.7

Cleaning the rinsing pump

N O T E
It is often possible to remove soiling from the rinsing device and rinsing pump by cleaning the rinsing
device without the nozzle/nozzles. (→ Cleaning the rinsing device)
► Remove the nozzle/nozzles for cleaning so that the dirt particles are flushed out.
Remove the filter drum to allow work to be carried out on the rinsing pump. (→ Removing/fitting the filter
drum)
How to proceed:
 Y
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Lift the rinsing pump, remove the rubber ring and filter sock.
– Clean all parts in clean water.
9.8

Replacing the rinsing pump

Remove the filter drum to allow work to be carried out on the rinsing pump. (→ Removing/fitting the filter
drum)
How to proceed:
 Z
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Loosen the hose clip and pull off the hose.
3. Take out the rinsing pump and replace.
– Disconnect the connection cable from the cable harness.
4. Fit the rinsing pump in the reverse order.
- EN -
71