Petsafe PIG19-16412 Gebrauchsanleitung Seite 10

Single or Double Loop Layout
The containment area can be created by using either a single boundary wire that is placed around the entire
property (3C) or by doubling the boundary wire along the same path (3E).
Single Loop Boundary
• To create a containment area for the entire property
• For exclusion areas around flower gardens, landscaping, or pools
With a single loop layout, the boundary wire starts at the fence transmitter, advances out to the garden,
continues all the way around the perimeter of the property and connects back to the fence transmitter. This
forms a boundary zone with a single wire.
3C
30 Twists/m
3D
Sample 1: Perimeter Loop (3C) The
perimeter loop is the most common layout.
This will allow your pet to freely and safely
C
roam your entire property. It can also protect
flower gardens, pools, and landscaping.
Sample 2: Full Perimeter Loop Using
B
Existing Fence (3D) This layout allows you
to include your existing fence as part of your
layout and keep your pet from jumping out
or digging under your existing fence. This
D
layout also greatly reduces the installation
time since most of the wire will not need to
A
be buried.
Run the wire from the fence transmitter to
E
point A, then to point B and so on (B to
C to D to E) all the way around the entire
property until back to point A again.
The wires from point A will then need to be twisted and connected back to the fence transmitter inside
your home.
10 petsafe.com