Pioneer CP-LX 70 Bedienungsanleitung Seite 5

4 Preparing to attach the speaker.
CP-LX70: Temporarily place the speaker stand upright, and detach
the bottom cushion material, leaving only the top cushion on the
floor. Place the speaker on the top cushion and place the speaker
stand on top of the speaker.
Speaker
CP-LX70TS: Temporarily stand the speaker stand upright, then turn
the bottom cushion material over and place the speaker on it. As
shown in the illustration, turn the top cushion material sideways
and orient it sideways to the stand, then rest the speaker stand
assembled in step 2 on it.
Speaker
Cushioning
material (Bottom)
5 Connect the speaker cable to the speaker.
Pull the speaker cable through the front side of the pillar (the
bottom side during assembly) and connect to the terminals located
on the backside of the speaker.
• Connect the speaker cable with the marking to the (+) terminal,
and the cable without the marking to the (–) terminal.
• If connecting the cords proves to be difficult, slightly move the
position of the pillar and speaker.
Cushioning
material (Top)
(Rear side)
Cushioning
material (Top)
(Rear side)
6 Secure the speaker.
Once the speaker is placed in the installation position, pull the
slack of the speaker cord and store in the bottom side of the stand
base as shown in step 3.
Next, place the speaker security plate on the pillar, and secure to
the speaker using the supplied screws (large).
• The speaker security plates are designed with a directional
orientation in which they are to be installed. Attach them so
that the side printed with "TOP" is oriented toward the top of the
speaker and pillar.
T O P T O P
Caution
Confirm that the speaker cable does not become pinched between
the pillar and the speaker.
Top
Bottom
5
En