Ventus W160 Bedienungsanleitung Seite 3

Loosen the screws on the battery door with a small screwdriver, insert 2 pieces of AAA batteries
according to the polarity indicated. Replace the cover and tighten the screws.
ALTITUDE SETTING
After battery installation, the main unit will enter altitude setting mode directly. Press "▲" or "▼" to
select the unit in meter or feet. Press "PRESSURE" to confirm. Then press "▲" or "▼" to enter your
current altitude. Press "PRESSURE" to confirm and exit the setting. This allows the unit to provide a
more accurate weather forecast reading. (For more information, see "WEATHER FORECAST &
BAROMETRIC PRESSURE" section)
SETTING UP THE WIRELESS THERMO-HYGROMETER:
For the first installation, always turn on the home unit and then the remote sensor. Set Channel 1
for the first remote sensor. Set channel 2 and channel 3 for the 2
Press and hold CHANNEL/SEARCH button on main unit until a beep is sound to search for
remote sensor.
Press the Tx button on the back of remote sensor to transmit RF signal.
When RF connection is established, the respective temperature & humidity of the selected
channel will appear on the main unit.
RADIO-CONTROLLED CLOCK
The unit will start synchronizing the clock after battery/adapter installation or reset. In normal mode,
press " " in the battery compartment to enforce searching of radio-controlled clock signal. The
antenna icon will appear during synchronization, if the icon disappear afterwards, radio time signal is
not available at the moment. Try other locations later. Place the unit away from source of
interference such as mobile phones, appliances, TV etc.
Antenna icon with full signal strength
time is successful. The radio-controlled clock will have a daily synchronization at 02:03 and 03:03
everyday. Each reception cycle is minimum 2.5 minutes and maximum 10 minutes.
WEATHER FORECAST & BAROMETRIC PRESSURE
The unit predicts weather condition of the next 12 – 24 hours based on the change of atmospheric
pressure. The coverage area is around 30 – 50 km. The weather forecast is based on atmospheric
pressure change and is about 70-75% correct. As weather conditions cannot be 100% correctly
forecasted, we cannot be responsible for any loss caused by an incorrect forecast.
will appear on screen if the reception of radio-controlled
nd rd
and 3 sensor.