Assembly; Unpacking; Placing The Appliance; Tightening The Funnel - Klarstein 10033209 Bedienungsanleitung

EN
34

ASSEMBLY

Unpacking

Carefully remove all packaging material before first use to avoid damaging the
appliance or impairing its functionality.

Placing the Appliance

Place the appliance on a plane and clean work surface away from hot surfaces and
heat sources such as heaters, stoves, ovens, open fires and surfaces in direct sunlight.
Also make sure that the power cord does not come into contact to hot surfaces and heat
sources.
Do not let the power cord hang over the edge of the work surface to prevent the
appliance from being accidentally torn off.
Unplug the power cord before cleaning the appliance and when not in use.
To unplug the appliance from the wall socket, turn off all switches, then unplug the
power cord from the wall socket by pulling the cord by its plug.
Inserting the Filter
1 To insert the selected filter in the metal funnel, make sure to align the notch on the
filter with the groove inside the funnel.
2 Turn the filter to the left or right to lock in place. This will help secure the filter in the
funnel.

Tightening the Funnel

1 Hold the metal funnel below the metal funnel holder and place it in the holder (see
Figure1).
2 NOTE: The metal funnel only fits in the funnel holder in a certain way. Do not force
it to fit.
3 Rotate the metal funnel counter-clockwise until it is tight in the holder and the handle
of the metal funnel points to you (see Figure 2 and 3).