Fermax DUOX Direct Installationsanleitung Seite 50

DUO DUO X DIRECT X DIRECT
DUO DUO DUOX DIRECT X DIRECT X DIRECT
DUO DUOX DIRECT DUO X DIRECT X DIRECT X DIRECT
DUO DUO X DIRECT
Cityline Amplifier
Carry out the following steps:
1. With the power off, remove the call extension module (only the 5 way cable, connected
to the CN1 on the amplifier).
2. Use the 5 way cable to connect the keypad as shown in the diagram.
3. Reconnect the power supply. Now you can program the required parameters with the
keypad.
4. Before completing the keypad disconnection operations and connecting the new call
extension module, remove the power.
Cable with 5 lines (the
call extension module
may be used)
PUT
NTRITT
Details: connect the 5 way cable to
the keypad (CN1) as shown in the
diagram (the right pin remains free).
NOTE:
- On the Cityline panels (continuous profile) if you must connect the keypad since the
amplifier connector (CN1) for the "call extension module" is 5 way, and the keypad
is 6 way, you have to connect with a 5 way cable by connecting the keypad on the
lines 1 to 5.
Pag 50
CN9
ENTRADA/INPUT
CN1
ARRIVÉE/EINTRITT
CN1
1 2 3
4 5 6
7 8 9
0 B
A
SALIDA/OUTPUT
SORTIE/AUSGANG
CN1
CN1
CN1 PACK EXTENSION
SW1
DL2
DL2 LED
SW1 PROG
CN9 TAMPER
ONE
TO
BUS
ONE
CN2 CN3 P2 B B C
UP
DUOX AMPLIFICADOR
AMPLIFIER
A
AUDIO
B
C
D
E
F
IDIOMA
LANGUAGE
EXIT
18Vdc
- +
S
NO NC BS GND
+12
NC
VERSION
C
NO
CN1
CN1
MÓDULO TECLADO
KEYPAD MODULE
MODULE CLAVIER
TASTATURMODUL
CN2
P1
: