Herunterladen Inhalt Inhalt Diese Seite drucken

auna 10027091 Bedienungsanleitung Seite 10

Retro plattenspieler
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Needle removal & installation
The record player is already fitted with a universal needle (or stylus) suitable for playing 331/3, 45 or 78rpm records.
The procedure for removing and re-fitting the needle is as follows:
Removing the needle holder
Gently pull down the tip of the stylus holder (1). Pull the cartridge forward (2). Pull it out and remove it from the tone
arm head (3).
Fitting a stylus cartridge
After following the "Removing the Needle Holder" instructions on the previous page, follow steps 1 to 4 below to refit
it:
1.
Position the red stylus holder with the Sapphire stylus facing down.
2. Line up the tab at the back of the stylus holder with the tone arm cartridge (see picture 1).
3. Insert the stylus holder with its front end at a downward angle (see picture 2 below).
4. Lift the front end of stylus holder upward until it snaps into place.
Additional Stylus Information
The red stylus holder has a very small Sapphire stylus tip that is barely visible.
replacement needle you purchased is the same as the needle already on the tone arm.
This universal needle is safe to use for all three (331/3, 45 & 78rpm) speed records.
Note: We do recommend that a needle specifically for use with 78rpm records is used if you are
going to play a lot of 78rpm records.
When to replace the needle depends on how often you use your turntable and the condition of
the records played.
The Sapphire stylus will give an average of 1000 hours playing time.
Line out
1. Connect the Auxiliary cable (not supplied) to the LINE OUT JACK on the rear of the record player
and the other end of the cable to the auxiliary inputs of the external component, e.g. another
Hi-Fi unit, Amplifier, PC, etc.
2. Check the volume level of your external component and adjust it if necessary.
3. Refer to the instruction manual of the external component for its correct operation.
Subwoofer out
The subwoofer output jack enables you to attach an active subwoofer (not supplied) which will
enhance bass response. Please contact your retailer for suitable subwoofer models.
Connections
Make sure the
10

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1002709010027092

Inhaltsverzeichnis