GGP ITALY 102 Gebrauchsanweisung Seite 52

1
Line up the hole on the steering wheel hub (4) with the hole on
the shaft (3) and insert the pin supplied (5) using a hammer,
ensuring that the end comes completely through to the oppo-
site side.
NOTE
To avoid damaging the steering wheel,
use a punch or a screw-driver of the same size as the pin
when hammering it in the last part.
3.3 FITTING
THE SEAT
Raise the adjustment
lever (3) and fit the
seat (1) in the slide (2),
introducing it from the
steering wheel's side,
till the seat engages in
one of the 6 positions.
EN 10
2
4
3
5
4
At this point the seat is engaged and cannot be completely
removed unless the lever (4) is pressed, freeing it from its
retainer.
3.4 ASSEMBLY AND CONNECTING THE BATTERY
The battery (1) is housed under the seat and secured by a
spring (4).
Connect the red cable (2) to the positive terminal (+) and the
black cable (3) to the negative terminal (–) using the supplied
screws and following the illustrated sequence.
Fit the spring (4) to hold the battery in place and make sure all
the wires are in front of the battery so that they don't get
caught in the spring (4).
3
2 1
IMPORTANT
ing to the instructions in the battery's manual (
4
1
Always fully charge the battery accord-
2
6.2.3).